Tag Archives: Rolleicord III

Rolleicord … the front end.

I was finally able to get a hold of a Rollei TLR. This Rolleicord III came in a pretty banged up state. The front cover metal was bent out of shape … and I think some prevous owner continued to use the camera. The mechanisms all appear to work, so my job is to get it somewhat back in shape.

I will say that TLR’s are one of the easiest cameras to work on … hmm, I think I may have said this before … as they seem to be so mechanically similiar that it is easy to work them out.

The hood did not close cleanly … this is because it was also bent out of shape. This was the easy part, as all I needed to do was lightly twist (and push) the opened hood until the metal leafs were back in alignment.

The magnifier was also too flappy … the pivoting pin has slipped out of one side. It appears that one of the metal sides was also bend out of shape, so just needed to be pushed back into position to keep the pin from moving sideways.

I ned to get the front cover off. Carefully peel off the leatherette. You should be able to get it off in one piece as it has a paper backing.

Note: if you just want to get at the blades you do not need to remove the cover. You can just unscrew the front element.

DSC00515

Next unscrew the knobs from the shutter, aperture, and speed arms.

The four large shiny screws hold the entire front onto the the rest of the camera. I suggest you go with the inner layers. Remove the four small brass screws hold the outside cover plate on. The next set of five screws holds the lens/shutter.

Lift and jiggle to get these two covers off.

DSC00526

You will notice that there is a hidden arm (lower left corner) that is coupled to the lens/shutter plate … this arm is used to move the paralax correcting screen in the viewfinder. Make a mark to note its position if you take the screw off.

Lets look at the shutter since we are here …

DSC00527

 

Very typical.

Unscrew the front lens element.

Then turn the lock.

Twist the cover to match up with the notches.

 

 

 

DSC00528

 

Always note the position of the speed cam … and all the little thingies that ride the grooves.

 

 

 

 

 

 

 

DSC00529

 

… and there we are.

The shutter cocking ring sits in the middle here and is spring loaded … so it may pop out. This image shows it in firing position.

 

 

 

 

You can continue to take of the rest of the front by removing the four large screws … and as I noted before, the arm for the parallax correction.

DSC00514

Note where the shims go.

At this point you can also get at the viewing mirror to clean it … but watch out for the ground screen.

 

 

 

 

The front cover was the major fault on this camera. The sides and top of the cover had been impacted by things (it had to be more than once to affect that many areas).

DSC00513

You can unscrew the retaing ring and all those layers of dials will slide right out.

Use a wood dowel and a hammer to tap out the dents.

Before putting it back together, remember to clean the old lube off and make the numbers easier to read.

Add a little dab of new lubricant between the dials. After you secure the retaining ring, make sure everything is moving smoothly.

Set the shutter and aperture to their topmost position so you know where they are when you put the front plate back on. Don’t secure it until you know that the dials have coupled with them properly.

Advertisements

%d bloggers like this: